Replacement of pool light fixture: $179
One On-Site Visit of Repair Tech I or higher to perform the following:
Cord becoming stuck: This is not common but can occur in about 3-5% of the lights we replace. Pool lights circuits have been done differently by different builders at different times. All pool lights have a conduit ran from a junction box to the pool niche which is where the light mounts. The light is immersed in water all the time as is the cord. The light cord and a very thick bond wire (#8 coated solid copper) are pulled through a conduit normally 1" sometimes 3/4" this is a tight fit and over time the cord can swell depending on water chemistry and other factors. If a light cord becomes stuck there may be additional labor in order to get it pulled out. I have had occasions where the whole bond wire had to be removed then all pulled through, that can require up to four hours to do with two techs on site and is bid by the hour. I have had a few occasions where the light cord could not be removed, that there was corrosion in the conduit and it was hopelessly stuck. It is rare, however it can occur.
Guarantee: All new light assemblies installed from All Clear come with a one year labor guarantee if the light fails for reasons other than misuse, dry firing, or neglect and is found to be under warrantee with the manufacturer. All Clear will replace or fix the light. The manufacturer warranty and conditions apply. There can be additional charges if cord is stuck or the other conditions mentioned above occur.