All Clear
  • Home
  • Services
    • Weekly Pool Service
    • Pool Service FAQ's
    • Service Areas
    • Repairs and Installation
    • Retail Stores
  • Email Coupon Signup
  • Service Coupon
  • Contact Us
    • Contact Us
    • How are we?
    • Locations & Hours >
      • Elk Grove Store
      • Arden Store
      • Greenhaven Store
  • Careers
  • About Us
    • About Us

Light Installation

Replacement of pool light fixture: $179

One On-Site Visit of Repair Tech I or higher to perform the following:
  • Check for GFCI branch circuit protection (main Panel)
  • Verify power is going through GFCI that protects the light circuit.
  • Verify power is going through switch and that there is power to light at junction box.
  • Disconnect power to light at junction box.
  • Remove one light from Niche,
  • Cut cord at light, and splice to new light cord.  tape this connection.
  • Pull new cord through conduit using old cord. 
  • Disconnect old cord and connect power at junction box.  Test circuit.

Additional charges may be necessary if the following conditions occur:
  • Pilot screw is stripped or breaks off when attempting to remove.
  • There is no bond wire attachment to niche or scotchcoat coating is missing
  • Pool light access is limited, such as too low in pool
  • Cord is stuck in conduit, this can be very problematic see below.
Schedule an installation
Note: Cord becoming stuck: This is not common but can occur in about 3-5% of the lights we replace. Pool lights circuits have been done differently by different builders at different times. All pool lights have a conduit ran from a junction box to the pool niche which is where the light mounts. The light is immersed in water all the time as is the cord. The light cord and a very thick bond wire (#8 coated solid copper) are pulled through a conduit normally 1" sometimes 3/4" this is a tight fit and over time the cord can swell depending on water chemistry and other factors. If a light cord becomes stuck there may be additional labor in order to get it pulled out. I have had occasions where the whole bond wire had to be removed then all pulled through, that can require up to four hours to do with two techs on site and is bid by the hour. I have had a few occasions where the light cord could not be removed, that there was corrosion in the conduit and it was hopelessly stuck. It is rare, however it can occur.
 
Guarantee: All new light assemblies installed from All Clear come with a one year labor guarantee  if the light fails for reasons other than misuse, dry firing, or neglect and is found to be under warrantee with the manufacturer. All Clear will replace or fix the light. The manufacturer warranty and conditions apply. There can be additional charges if cord is stuck or the other conditions mentioned above occur.
Picture

Home

Services

About

testimonials

Contact

​Copyright © 2016  |  All Clear Pool & Spa  |  All Rights Reserved.
Pool Supplies, Service, and Repairs. Located in  Elk Grove, Sacramento, Galt and Arden.
Main store: 9156 Elk Grove- Florin Rd. Elk Grove, CA 95624
Contracters License #681954
  • Home
  • Services
    • Weekly Pool Service
    • Pool Service FAQ's
    • Service Areas
    • Repairs and Installation
    • Retail Stores
  • Email Coupon Signup
  • Service Coupon
  • Contact Us
    • Contact Us
    • How are we?
    • Locations & Hours >
      • Elk Grove Store
      • Arden Store
      • Greenhaven Store
  • Careers
  • About Us
    • About Us