Pump Installation

This provides a one-trip call in order to install a Pump that has been predetermined to need replacement. A picture of the current installation can reduce additional trip charges due to some unforeseen part or adapter needed.

One on-site visit includes:

  • Verify GFCI Branch circuit protection.

  • Remove the old pump

  • Disconnect and inspect the conduit on the old pump.

  • Plumb in the new pump (materials are additional costs)

  • Attach conduit and bond wire to new pump

  • Add a water pump/prime system.

  • Visually look over equipment to verify if the system runs correctly.

  • Haul away old pump to recycle whatever materials can be.


This price assumes that there is a pad in place to put a new pump and that the plumbing is PVC. If these conditions are not present there will be additional charges to put a pad in or to adapt to copper plumbing.
All materials needed to install the pump are at an additional charge. This installation does not include the installation of valves or any other components, (those are an additional fee).


Warranty:  Pumps purchased through All Clear come with a 1 to 10-year guarantee against defects through the manufacturer depending on the Pump model and manufacturer (we act as an intermediary on your behalf). This warranty is from date of installation or purchase. Please visit the manufacturer's website to confirm actual warranty or see paperwork left with you on-site.

* Pump running dry can void manufacturers' warranty. Impellers and internal parts showing heat damage may not be covered. These components are always covered with water so there is no reason they will heat up or show any signs of heat damage unless the pump runs dry.  This will be visible, in heat damage to plastic components and vulcanization of rubber. Most manufacturers allow us to fix this once as a courtesy, however, if it occurs again, they may not if that is the case the following will occur. If we determine that the damage was caused by heat in the first YEAR we will offer a 50% off labor and 30% off the replacement parts that are needed to bring it back to compliance. This is assuming that the manufacturer will no longer cover it. The tech will then look over the system to see if there is a cause they can see that caused it to run dry besides water level. The first 15 minutes of this troubleshooting is customer courtesy. If the tech determines more time is necessary he will provide an estimate of what is causing it or what needs to be repaired.

Contact

(916) 686-7665

info@shopallclear.com

Address

9156 Elk Grove Florin Rd.
Elk Grove, CA 95624

©2020  - ALL CLEAR POOL & SPA